The Sub-2 module operates jointly with the Full modules on 3- to 5-path systems.
Main features of the Sub-2 + Full Module:
mark.gif (41 bytes)

-

Variable cutoff frequency splitter and selection via Microswitch,

 

with 24dB per octave (4th order) Linkwitz-Riley with state variable topology.

-

Independent gain for subbass, bass, mid-bass, mid, and treble sounds.

-

Variable low-frequency (high-pass) filter,

 

with 18 dB per octave. Provides a perfect setting for the system low end.

-

Variable high-frequency (low-pass) filter,

 

with 18 dB per octave. Feeds perfectly your drivers and tweeters.

-

Adjustable treble equalizer filter of +3 or +6dB for titanium driver.

-

Bass equalizer filter with Q=2,

 

for equalization of bass reflecting speakers (Vented box or Band pass).

-

Variable limiter independent from the gain control, for bass and treble sounds.

 

Crest Factor limiter
The only system to accurately set the amplifier power for each type of speaker.

-

Balanced input with XLR connector and XLR signal distribution output.

Technical Specifications:
.Sub-2 Module.
-Signal/noise ratio *Better than 90 dBA
-Inter-channel separation *Better than 50dB
-Harmonic distortion *Lower than 0.05% uncompressed
*Lower than 0.5% with a 6dB compression
-Input impedance *10kohm balanced
*5kohm unbalanced
-Crossover *Linkwitz-Riley 24dB/octave, State Variable topology,
Frequency selection from 60Hz to 380kHz.
-Maximum input level *+16dB
-Maximum gain *+9dB
-Internal connection *Standard 16 pins, Plug&Play Studio R
-Panel connectors *Balanced input: 3-Pin XLR connector, female
*Output: 3-Pin XLR connector, male
-Maximum output signal *+9dB with limiter
*+18dB without limiter
-Dimensions *125mm X 74mm X 165mm
-Weight *240g
-Reference for specifications *1V RMS of input